charge gas

英 [tʃɑːdʒ ɡæs] 美 [tʃɑːrdʒ ɡæs]

网络  原料气

化学



双语例句

  1. When the wave wells up the regulation that the voltage is greater than the gas and in charge of, gas in charge of discharge earth connection too high voltage, Protect the apparatus systematically.
    当浪涌电压大于气体管的规定时,气体管会将过高的电压放电接地,保护系统器材。
  2. After using oil injection instead of water, analysis is also given to the actual situations of after-cooler of charge gas compressor and inter-stage tank. THE BEHAVIOR OF THE FLUID MECHANICS AND THE CHARACTERISTICS OF MASS TRANSTER IN DSC REACTOR
    分析了由注油改为注水后,裂解气压缩机后冷器和段间罐的情况。馏分油选择裂解反应器的流体力学行为及传质特征分析
  3. Never use canned air or gas to clean the sensor. After using oil injection instead of water, analysis is also given to the actual situations of after-cooler of charge gas compressor and inter-stage tank.
    绝对不要使用任何罐装压缩空气或液化气清洁感应器。分析了由注油改为注水后,裂解气压缩机后冷器和段间罐的情况。
  4. Surface and space charge measurement of gas discharge
    气体放电表面电荷和空间电荷测量方法
  5. A charge of gas is compressed inside the chamber. 4-Cylinder Engines imported from Chrysler
    一次进汽在汽缸里面受到压缩。一汽引进的克莱斯勒四缸系列汽油机
  6. It expoundes basic moving laws of furnace charge and gas from HC FeCr smelting in electric arc furnace.
    论述了矿热炉冶炼高碳铬铁炉内炉料和炉气的基本运动规律。
  7. Water injection system for charge gas compressor is introduced in the article and comparison is made for charge gas compressor with water injection and oil injection.
    介绍了裂解气压缩机注水系统,对压缩机注油与注水进行了比较。
  8. This innovation is of great use for the design or renovation of the charge tower for gas and liquid transfer quality in the future.
    该方法可供气、液传质填料塔设计或改造时参考、借鉴。
  9. Design and Application of a Reasonable Charge of High-Energy Gas Fracturing
    高能气体压裂合理装药量的设计与应用
  10. In the study of the hydraulic motor-accumulator system, it is generally simplified as a gas springs, instead of taking the energy loss caused by heat transfer between the charge gas and the accumulator walls into account.
    这种系统的研究一般仅把蓄能器看成&气体弹簧,没有考虑气体与环境热交换而产生的能量损失。
  11. The effect of the coated propellant charge controlling gas producing rate, lowing ballistic temperature coefficient and improving the muzzle velocity is partly came from the effect of the coating layer.
    包覆火药装药控制燃气生成速率、降低弹道温度系数、提高弹丸初速的效果部分来自于包覆层的作用。
  12. The Innovation& Market of IC Card Advance Charge Intelligent Gas Meter
    IC卡预付费智能燃气表的开发与市场分析
  13. The property of initial installation charge for pipeline gas is analyzed, and the necessity for collecting the charge is expounded.
    分析了管道燃气初装费的性质,阐明了收取燃气初装费的必要性。
  14. The affection of different charge gas to process parameter was also invested.
    同时,还考察了原料气的轻重程度不同对最优工艺参数的影响。
  15. Approaches for the measurement of spatial charge in solid dielectrics are reviewed, surface charge on the surface of insulator and pre-discharge charge in gas dielectrics.
    对固体介质内部空间电荷、介质分界面处表面电荷及气体介质内部空间预放电电荷的测量技术进行综述。
  16. Entrainment is very small ( 0.034%~ 0.13%) and increases with the increasing of the charge of gas.
    气-液两相进料时雾沫夹带率为0.034%~0.13%,随着气体负荷的增大而增大。
  17. The capillary discharge experiment is proceed at capillary charge filled with Ar gas.
    从国外实验放电结果出发,推断了充气毛细管的阻抗特性。
  18. On the basis of numerous ambient temperature testing, the influence of dust dis-charge, gas inlet and gas extraction system on separation property of cyclone was researched emphatically.
    在大量常温试验研究的基础上,着重研究了排灰与进、排气系统对旋风分离器性能的影响。
  19. Turbine axial displacement fault analysis and modification for charge gas compressor
    裂解气压缩机的透平轴位移故障分析及改进
  20. The method of position sensing by charge division in gas sampling shower counter
    气体取样簇射计数器中的电荷分配定位
  21. Model Research on the Effects of Space Charge on Gas Discharge
    气体放电过程中空间电荷作用的模型研究
  22. The heat-transfer equation is established, and the relationship, in which temperatures of charge and gas change with time in the upper part of the blast furnace, is found by solving the equation. The uses of the relationship are explained.
    建立了传热方程,通过求解,得到了高炉上部区域炉料温度和煤气温度随时间变化的关系式,并说明其用途。
  23. The discharge breakdown time, peak current as a function of charge voltage and buffer gas are obtained.
    得到了放电击穿时间、放电峰值电流随充电电压、不同气体介质变化的曲线;
  24. In MPT system, the microwave resonator is the important component, which is in charge of the gas propellant's absorbing and transforming the microwave energy, just like the combustion chamber in chemical propulsion.
    在MPT中,微波谐振腔是工质吸收与转换微波能量的重要场所,它的功能和化学推进的燃烧室一样。
  25. Application of Electric Governor to Charge Gas Compressor in Ethylene Unit
    电子调速器在乙烯裂解气压缩机的应用
  26. The discharge peak currents and corresponding impedances of laser cavity at various charge voltages and gas pressures were studied.
    研究了放电峰值电流和平均阻抗与充电电压和气体压力的关系。
  27. The burden distribution and charge column permeability for gas were improved after the multi-ring burden distribution was adopted.
    高炉采用多环布料后,炉料分布合理,料柱透气性改善。
  28. Exhaust system not only affects the exhaust emission, but also have a major impact on Waste gas energy using 、 charge replacement 、 Pump gas losses and Diesel performance for the sequential turbocharged diesel.
    排气系统不仅影响废气的排出,而且在增压柴油机中,排气管中气体的流动对其废气能量的利用、充量更换、泵气损失及柴油机的性能都有重要的影响。
  29. The mechanism, influencing factors, distribution and control methods of electrostatic charge in gas phase fluidized bed are investigated in this paper.
    本文探讨了气相流化床反应器静电生成的机理、影响因素以及控制方法。
  30. Chare gas centrifugal compressor is the key equipment in olefins recovery unit which is part of the methanol to olefins unit, the role of the compressor is to improve the pressure of charge gas to provide conditions for the subsequent separation.
    反应气压缩机是甲醇制烯烃中烯烃分离单元的关键设备,其作用是提高气体压力为后续的分离提供条件。